
Refined flour (maida)
Snow-white maida, powder-soft and fine, puffing into golden, pillowy bhaturas and delicate, flaky parottas that crackle warm from the pan.
Also called: maida (Hindi)
Texture: Its gluten makes a stretchy dough, and it gives gravies a cloudy, opaque body.
Getting it ready
Half maida and half atta gives a softer lachha paratha. Outside India, plain flour rather than bread flour is the closest match. Cook a maida-thickened gravy at least 5 minutes more to lose the raw taste.
Swaps
- pulses (class): thickening blended soups Few sources say this.
- rice flour Few sources say this.
- whole wheat flour (atta): maida can be replaced
Keeping
Maida keeps less well than semolina, because its fine particles expose more surface to spoilage.
Goes well with
Used in
Puri, Bhatura, Gulab jamun, Luchi, Patishapta pitha, Rice roti, Papdi chaat, Malabar parotta, Naan dough, Samosa dough, White sauce, Olive chutney, Jalebi, Malpua, Ghevar, Balushahi, Cham cham, Khaja, Mysore pak, Puran poli, Karanji, Shakarpara, Samosa, Khasta kachori, Mathri, Kadhi pakora, Kuzhi paniyaram, Lauki kofta, Malai kofta, Mangalore buns, Mysore bonda, Namak para, Rava dosa, Rumali roti, Shukto, Veg cutlet
Tradition
Bengali luchis are small maida puris eaten at all meals in place of chapatis.
How it is made
Refined.
Maida is milled from cleaned wheat with the bran and germ taken off, and the white endosperm is ground very fine.
Maida is whitened with benzoyl peroxide or chlorine dioxide, which break down the carotenoids that tint wheat flour yellow; unbleached flour stays off-white.
Atta needs more water than maida: for naan, plan about 1 cup water for 3 cups atta, against starting at 3/4 cup with maida.
Chakki atta is the whole kernel ground with nothing sifted out; roller mills separate the parts and usually leave the germ out even when bran is added back.
Bread is officially defined as baked from atta and/or maida with water, salt and yeast or another leavening.
Seasonal food wheel
- On the tongue: Hearty
- After the meal: Hearty
- Warmth: neutral
- Texture: smooth
- Best seasons: summer, autumn, rains
Questions answered
Useful tips
- Maida thickens cloudy, cornflour thickens clear. Maida gives a cloudy, opaque gravy while cornflour gives a clearer, glossier one, because flour carries protein and other non-starch parts. Few sources say this.
- Luchi uses maida. Make luchi with maida; with atta it becomes a North Indian puri.
- Use more water when atta replaces maida. Atta needs more water than maida: for naan, plan about 1 cup water for 3 cups atta, against starting at 3/4 cup with maida.
- Atta is more nourishing than maida. Whole wheat atta has more protein, iron and thiamin than refined maida. Few sources say this.
- Maida keeps less well than rava. Maida keeps less well than semolina because its fine particles expose more surface to spoilage. Few sources say this.
- Maida carries far less thiamin and iron than atta. Unenriched maida has about a tenth of the thiamin of whole wheat atta and about a fifth of its iron, with much less fibre. Few sources say this.
- Indian wheat is soft; plain flour matches maida. Ordinary plain (all-purpose) flour is the closest match for maida.
- Choose clean, dry maida and sift it. Buy maida with no lumps, damp, insects, debris or damaged packaging, and sift it before use; colour is not a reliable sign of quality. Few sources say this.
- How maida is milled. Maida is milled from cleaned wheat with the bran and germ taken off, and the white endosperm is ground very fine.
- Official limits show what maida loses. Official standards cap maida at 1.0% ash, half the 2.0% allowed for atta, reflecting removal of the bran; atta may carry up to 2.5% crude fibre. Few sources say this.
- Bleaching and maturing maida. Maida is whitened with benzoyl peroxide or chlorine dioxide, which break down the carotenoids that tint wheat flour yellow; unbleached flour stays off-white.
- Why atta dough is less elastic than maida dough. Maida, being pure endosperm, builds a strong stretchy gluten network, while bran particles in atta cut through gluten strands and make the dough less elastic. Few sources say this.
- Maida binds lacy dosa. Maida in a lacy dosa batter binds it so the thin dosa does not tear when lifted.
- Why rava dosa uses maida and rice flour. Maida gives the lacy rava dosa enough stretch and binding not to tear, while plain unroasted rice flour makes it crisp.
- Maida-atta mix for softer lachha paratha. Lachha paratha dough can use some milk in place of part of the water. Few sources say this.
- Knead maida bread doughs long and elastic. Knead parotta and bhatura doughs very well, 12-15 minutes, until soft, supple and elastic; a press should leave a dent and it should stretch.
- Making bhatura with atta instead of maida. A little semolina can make all-atta bhaturas crisper and fluffier. Few sources say this.
- Adhirasam dissolves in oil. Adhirasam that dissolves in oil usually has too much jaggery or overcooked syrup; add the syrup gradually and work in a little more rice flour or maida to fix.
- Simmer a starch-thickened gravy a few minutes more. After a besan, maida or cornflour gravy has thickened, keep it cooking for at least about 5 minutes so the raw starchy taste cooks out. Few sources say this.
- Dissolve sugar for shakarpara dough. Dissolve or grind the sugar fully before it meets the maida for shakarpara. Few sources say this.
- Whole wheat and air-frying for shakarpara. Whole wheat flour can be used: half atta, half maida keeps shakarpara flaky, while all atta makes them denser. Few sources say this.
- Patishapta crepe: one side and flour mix. Cook patishapta crepes on one side only; maida keeps them thin while semolina and rice flour add bite.
- All-atta namak para is heavier. Namak para made with only whole wheat flour need more water and come out heavier than maida ones. Few sources say this.
Another view: Some cooks find the whole-wheat (atta) version loses nothing in texture compared with maida.
- Mysore bonda batter: froth the curd, rest and beat. For maida-curd Mysore bonda, let soda and salt froth in the curd about 5 minutes before adding flour, then rest the batter (one recipe says 4 hours) and beat again.
- Rumali roti dough is softer than chapati dough. Make rumali roti dough smooth, slightly sticky and softer than chapati dough; more maida gives softer rotis.
- Finishing shukto with milk and bori. Shukto is finished by stirring in a little milk mixed with a pinch of maida and simmering 3-5 minutes, with ground radhuni sprinkled over at the end.
- Lump-free coating slurry for cutlets. Whisk the maida and cornflour slurry until free of lumps before dipping cutlets. Few sources say this.
- Shaping and coating lauki koftas. Oil your palms before rolling lauki koftas so the mix does not stick, and dust them with cornflour or maida for a crisper shell. Few sources say this.
- Mysore bonda base. Mysore bonda batter is either maida with curd or one based on urad dal.
- Rub a little hot oil into fried-snack dough. Rub some hot oil through the dough for khaja and other sorghum-maida fried snacks while mixing.
- Bengali and northern luchis. Bengali luchis are usually 4–5 inch maida puris that can be eaten at any meal in place of chapatis; a northern luchi is 8–9 inches, paper thin and lifted out pale and chewy. Few sources say this.
- Official definition of bread. Bread is officially defined as baked from atta and/or maida with water, salt and yeast or another leavening. Few sources say this.
- Binding the malai kofta mixture. Mash boiled potatoes thoroughly with fresh, moist paneer and add some maida, which soaks up moisture and binds the mix so the balls hold.
- Ghevar. Ghevar is a cake of maida that is fried and then dipped in sugar syrup.
- Batter spreading in the oil: too thin, or fat too hot. If jalebi or imarti batter spreads in the oil, either the batter is too thin (stir in a little flour) or the oil is too hot; it should never smoke.
- Ghevar batter too thick. Too thick a ghevar batter sinks in the fat and will not form the mesh. Few sources say this.
- Add flour to jamun dough gradually. Add flour or semolina to gulab jamun or pantua dough little by little, and fry one test ball first; too much makes them chewy.
- A little starch stops milk curdling in tomato gravies. Thickening milk with a little flour first makes it less likely to curdle when heated hard or when tomato is added. Few sources say this.
- Getting moyan right in mathri and kachori dough. Melted fat coats flour more and gives a tender, mealy dough, while cold solid fat rubbed in leaves lumps that melt into flaky layers. Few sources say this.
Another view: Some karanji recipes rub hot ghee into the flour for a flaky cover; others find melted fat gives a tender, crumbly dough and cold solid fat gives flaky layers. Hot ghee mixed into the flour makes the cover flaky.
- Rub oil into samosa dough until it looks like breadcrumbs. In doughs where oil is rubbed in, the flour and spices are usually worked with the fingertips until the mix looks like breadcrumbs before water goes in. Few sources say this.
- Supermarket whole-wheat flour versus Indian atta. Soft-wheat whole-wheat flour is coarser and makes heavier breads than Indian atta; without atta, mix whole-wheat and all-purpose flour 2:1. Few sources say this.
- Thickening olive chutney. Boil olives until tender before adding sugar and reducing; a little plain flour slurry stirred in at the end thickens the syrupy chutney.
- Pipe jalebi and imarti into cooler fat, then raise the heat. Pipe jalebi or imarti into fat on low to medium-low heat, then raise it to medium or medium-high to crisp them; too hot while piping breaks the shape.
- Oil test for slow-fried sweets. For imarti and balushahi, a test drop should sizzle gently and rise slowly; if it shoots up or floats at once, the fat is too hot.
- Fry balushahi slowly so the centre cooks. Fry balushahi on low heat; high heat colours the outside while the inside stays raw.
- Piping hole size sets jalebi and imarti thickness. A wider tip gives thicker jalebis; keep the hole small for imarti, because the batter puffs up in the oil.
- Beat jalebi batter for volume. Stir jalebi batter briskly in circles for about 4 minutes so it gains volume and turns smooth and flowing. Few sources say this.
- Balushahi dough: rub in, barely knead. For balushahi, rub cold butter into the flour and bring the dough together gently, without much kneading. Few sources say this.
- Malpua batter consistency. Malpua batter should flow; add milk if it is too thick, or a few tablespoons of flour if it is too thin. Few sources say this.
- Khaja dough and frying fat. Keep khaja dough semi-soft for flaky layers, seal the rolls well, and fry in ghee or a neutral oil, not sesame, mustard or olive oil.
- Hot ghee and a firm dough for karanji cover. Mix hot ghee into the flour to make the karanji cover flaky, and keep the dough firm yet pliable, since a soft dough soaks up more oil. Few sources say this.
- Rest and roll karanji dough thin. Rest karanji dough so the gluten relaxes and it rolls easily, then roll the cover thin; a thick cover fries less crisp. Few sources say this.
- Seal fried pastries completely. Seal karanji and khaja edges completely, so they do not open in the oil; leaking filling clouds the oil, which then needs filtering.
- Do not overfill stuffed sweets. Do not overfill karanji or til pitha; a modest amount of filling keeps them easy to seal and shape.
- Keep sweet doughs covered. Keep dough, shaped karanji and cut shakarpara under a damp cloth or covered so they do not dry out; keep til pitha rice flour packed and covered too.
- Traditional and alternative karanji covers. Traditionally the rested karanji dough is pounded in a stone mortar 15–20 minutes; an oiled sheet rolled into a log gives layered covers. Few sources say this.
- Fry shakarpara on medium-low. Fry shakarpara on medium-low heat; on a high flame they brown before the centre cooks and do not turn crisp.
- Semolina for crunch in shakarpara. Knead a little rava into shakarpara or shankarpali dough for extra crunch.
- Press test for rubbed-in ghee. Enough ghee has been rubbed into the flour for shakarpara when a pressed handful holds its shape. Few sources say this.
- Typical moyan ratio: about 2 tablespoons fat per cup of flour. For mathri and nimki, about 2 tablespoons of oil or ghee per cup of flour (a quarter cup for two cups) is the usual moyan.